Polysun Simulation Software Community

To whom it may concern, during the workout of polysun, we found a number of problems:

1. Everytime we try to move a component of the system graph, there is a new pop up window asking me to create a new system (as shown in the graph below). Is it a bug or something that has to happen when modifying the system?

2. When adding a component, sometimes it takes 5 or 6 times to overcome the pop up window before a new component appears.

3. Would it be a classification on which way is the inlet-outlet of the components, such as at ground source heap pump (as shown below).
It would be great if I can know which port is the right one.

Thank you very much!

------
System: windows 10
Polysun Version 10.0

Dear yihe,

1) pop up window: this appears since you did not created a variant. If you choose a certain variant from the variant tree and confirm that you are going to work with it you will be able to change also the components and run simulations.

2) same issue

3) the components recognize automatically (from the flow rate) the inlet and outlet - it does not mater for the calculation how you connect it

BR Lars

Get it, thank you very much!