Hot source and problem of too many cold input
Verfasst: Mo Apr 29, 2019 2:28 pm
Good afternoon,
in the solution presented in the attachment, I would like to insert in point 3 a hot water source (95 ° C) and consequently cold in 4.
Currently, as input I found only a cold source. Is there a possibility to change fluid temperatures?
Furthermore starting the simulation the following problem occurs: too many cold inputs. (Attached)
If I change an input from water to ORC and the other from cold water to hot water, would you solve the problem?
Waiting for an answer.
Best regards
in the solution presented in the attachment, I would like to insert in point 3 a hot water source (95 ° C) and consequently cold in 4.
Currently, as input I found only a cold source. Is there a possibility to change fluid temperatures?
Furthermore starting the simulation the following problem occurs: too many cold inputs. (Attached)
If I change an input from water to ORC and the other from cold water to hot water, would you solve the problem?
Waiting for an answer.
Best regards