Hot source and problem of too many cold input

The forum for students and lecturers for questions and discussions about Polysun for academic use
Post Reply
TurCoim
Posts: 10
Joined: Tue Apr 09, 2019 2:55 pm

Mon Apr 29, 2019 2:28 pm

Good afternoon,

in the solution presented in the attachment, I would like to insert in point 3 a hot water source (95 ° C) and consequently cold in 4.

Currently, as input I found only a cold source. Is there a possibility to change fluid temperatures?

Furthermore starting the simulation the following problem occurs: too many cold inputs. (Attached)

If I change an input from water to ORC and the other from cold water to hot water, would you solve the problem?

Waiting for an answer.
Best regards
Attachments
system.PNG
system.PNG (42.32 KiB) Viewed 71 times
error1.PNG
error1.PNG (50.49 KiB) Viewed 71 times

nmarthaler
Posts: 40
Joined: Mon Jun 18, 2018 4:01 pm

Tue Apr 30, 2019 2:32 pm

Hello TurCoim

Yes, there is a possibility to change the temperature. You can do it by modifying the cold water supply file.
No, it won't since you can only have one hot and cold water supply per loop.

Sunny greetings
Nathanael

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 0 guests