Polysun Simulation Software Community

Good morning,

I'm a student who is using Polysun software, version 11.0.

I have two doubts.

I would like to make a simulation in which an organic fluid (other than the default water) is present on one side of the external heat exchanger. How could such a simulation be done? I tried to insert the inlet and outlet pipe but only water is the option.

Another general question is related to the correct procedure for changing the default parameters. (I tried to copy them and then edit them as I did with the previous version, but it gives me an error). What then would be the correct procedure for replacing the parameters?

I await cordial your reply.
Thank you in advance for your support

Good morning TurCoim

Please sync your Polysun license and are going to be able to copy and change existing catalog entries.

Changing fluid:
1. Double click on one of the tubes in the circuit in which you would like to have your organic fluid
2. Component window pops up and click on the 4th icon on top (blue arrow)
3. Change the fluid of your desired circuit by using the yellow pen

Best regards
Nathanael