Heat Load Profile for buildings

The forum for all questions and discussions about Polysun Simulation Software (Designer / Standard)
Post Reply
Zaideus
Posts: 13
Joined: Tue Oct 24, 2017 12:33 pm

Fri Oct 18, 2019 10:54 am

Hallo forum members,

Is there any way of generating the 'correct' heat load profile of a non-residential building when only the annual heat consumption is known (not the hourly heat demand) and a quasi-dynamic or degree-hours model is chosen?
It seems that Polysun by default assumes that it is a residential building which is often not the case.
It would be great if someone can help me with this. Thank you.

-Zaideus

nmarthaler
Posts: 58
Joined: Mon Jun 18, 2018 4:01 pm

Thu Oct 24, 2019 5:08 pm

Hi Zaideus

Did you try to adjust the following parameters: heating set point temperature, activation of heating loop or the heating curve?
The other option would be, you are going to create your own profile or a monthly based profile in the building GUI.

Sunny greetings
Nathanael

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 0 guests