Seite 1 von 1

Simulating SWH for an eletrcoplating process  Thema ist als GELÖST markiert

Verfasst: Di Jun 01, 2021 5:01 pm
von nadaali
Hello....

I am trying to simulate heating a chemical to 60 degrees and the chemical is in an open tank, so I used the pool element resembling the open tank. The liquid in the open tank is heated via a heat exchanger in the storage tank with a pump in between. I attached a picture of the diagram.

I receive a error message with simulation that says The water loop does not contain flow rate producers although I have a pump. Any clues what should I try?