I am trying to simulate heating a chemical to 60 degrees and the chemical is in an open tank, so I used the pool element resembling the open tank. The liquid in the open tank is heated via a heat exchanger in the storage tank with a pump in between. I attached a picture of the diagram.
I receive a error message with simulation that says The water loop does not contain flow rate producers although I have a pump. Any clues what should I try?
The forum for all questions and discussions about Polysun Simulation Software (Designer / Standard)
1 post • Page 1 of 1
Who is online
Users browsing this forum: No registered users and 8 guests