Simulating SWH for an eletrcoplating process Thema ist als GELÖST markiert

The forum for all questions and discussions about Polysun Simulation Software (Designer / Standard)
Antworten
nadaali
Beiträge: 1
Registriert: Di Jun 01, 2021 4:30 pm

Di Jun 01, 2021 5:01 pm

Hello....

I am trying to simulate heating a chemical to 60 degrees and the chemical is in an open tank, so I used the pool element resembling the open tank. The liquid in the open tank is heated via a heat exchanger in the storage tank with a pump in between. I attached a picture of the diagram.

I receive a error message with simulation that says The water loop does not contain flow rate producers although I have a pump. Any clues what should I try?
Dateianhänge
Capture.PNG
Capture.PNG (32.58 KiB) 8310 mal betrachtet

Antworten
  • Information
  • Wer ist online?

    Mitglieder in diesem Forum: 0 Mitglieder und 6 Gäste