Simulating SWH for an eletrcoplating process Thema ist als GELÖST markiert

The forum for all questions and discussions about Polysun Simulation Software (Designer / Standard)
Post Reply
nadaali
Posts: 1
Joined: Tue Jun 01, 2021 4:30 pm

Tue Jun 01, 2021 5:01 pm

Hello....

I am trying to simulate heating a chemical to 60 degrees and the chemical is in an open tank, so I used the pool element resembling the open tank. The liquid in the open tank is heated via a heat exchanger in the storage tank with a pump in between. I attached a picture of the diagram.

I receive a error message with simulation that says The water loop does not contain flow rate producers although I have a pump. Any clues what should I try?
Attachments
Capture.PNG
Capture.PNG (32.58 KiB) Viewed 24 times

Post Reply
  • Information
  • Who is online

    Users browsing this forum: No registered users and 1 guest