Seite 1 von 1

Hot source and problem of too many cold input

Verfasst: Mo Apr 29, 2019 2:28 pm
von TurCoim
Good afternoon,

in the solution presented in the attachment, I would like to insert in point 3 a hot water source (95 ° C) and consequently cold in 4.

Currently, as input I found only a cold source. Is there a possibility to change fluid temperatures?

Furthermore starting the simulation the following problem occurs: too many cold inputs. (Attached)

If I change an input from water to ORC and the other from cold water to hot water, would you solve the problem?

Waiting for an answer.
Best regards

Re: Hot source and problem of too many cold input

Verfasst: Di Apr 30, 2019 2:32 pm
von nmarthaler
Hello TurCoim

Yes, there is a possibility to change the temperature. You can do it by modifying the cold water supply file.
No, it won't since you can only have one hot and cold water supply per loop.

Sunny greetings
Nathanael